Plunger, plunger, toil and trouble. That old rhyme doesn’t begin to describe the horror of a clogged toilet. The good news is that you don’t have to call in the plumbers for every toilet issue; after all, if you don’t live in the 1700s and have access to modern plumbing tools, there must be an easier way! This guide will teach you how to unclog a toilet with a plunger so you never have to worry about being one of those people who ends up with a flooded bathroom or worse — having someone else do it for them because they were too embarrassed to admit they couldn’t handle their own messes.
Steps to Unclog a Toilet with Plunger!
It’s important to have the right tools for the job. The best way to plunge a toilet is to use a toilet plunger. These are designed to fit on the end of your toilet and can be used to create suction inside the bowl, which helps break down any toilet bowl clogged. The steps are:
1. Add Water to the Bowl
The first step is to add water to the bowl. You may be tempted to fill it all the way, but don’t do this—the water level should be about one or two inches below where the plunger will make contact with the water. If you are unsure how to use a plunger, avoid using too much force. You want your plunger to touch only one side of the toilet at a time so that you can get good leverage on it and avoid putting damaging pressure on your toilet’s flange (the part connecting your toilet bowl with its drain).
You’ll also want to make sure there’s enough clean water in the bowl for all of this work!
2. Place the plunger into toilet bowl.
To begin, you’ll need to place the plunger in the toilet bowl. Make sure not to flush the toilet again until you’ve removed all of this water. If you do flush again, it could cause more problems and make it harder for your plunger to work properly.
Next, find a plunger that is appropriate for your toilet: one that is too big or small will cause problems with clogging and waste time by needing to be readjusted constantly during use. As well, if there is a hole in the bottom of your plunger (as some models have), this can also affect its effectiveness at removing blockages from toilets.
Explore Our Other Home Painting Articles:
- How Much does it Cost to Paint a House interior?
- How to Paint Kitchen Cabinets Without Sanding?
- How to Paint a Bathroom Vanity?
- Can You Paint Bathroom Tile?
3. Pull and push the plunger in a continuous motion.
The process to unclog toilet with a plunger is pretty straightforward. First, place the plunger over the drain and press it down until you feel it contact the clog. Then, pull up on the plunger with steady force. Repeat this motion until you see water begin to drain through your drainpipe or can hear gurgling sounds coming from inside of your toilet tank.
If you’re dealing with stubborn clogs that require extra muscle power, try first pushing down on the plunger and pulling up quickly, then pushing down again while pulling up slowly. This should give enough momentum for water to begin draining through your pipes once more! So this is how to unclog a toilet with a plunger
4. Empty toilet bowl, if necessary.
If you have a bucket, use it. If not, aim for the toilet bowl itself. The plunger should be placed in such a way that water will not spill over the side of your sink or tub when you push down on it. Then, push down hard with all your might until a large amount of water comes out from under where your plunger is touching and into your bowl. This is called “flushing” or “pumping” and assures that there are no clogs closer than several feet downstream from where they had been before!
If there’s still no flow after this first step, try pushing again in different directions around the perimeter of where you pushed last time so as not to miss any potential blockage points nearby.
Explore Our Others Home Repairing Articles:
- How Patio Sliding Door Repair and Installation
- How Sliding Glass Door Repair
- How to Repair Water Damage Drywall
Hopefully, you’ve mastered the art of unclogging a toilet with a plunger. If you still are unsure about how to unclog a toilet with a plunger, don’t worry! Keep on reading the whole information again. The most important thing is to keep trying until you succeed—because when your toilet clogs up, there ain’t no time for failure.
Please Explore more Guide: How to Fix a Broken Garage Door Spring